Our newly developed HIGHSIDER CAN-BUS resistor CBW1 is compatible with most vehicles equipped with a CAN-BUS system.
The resistor CBW1 provides a required electrical load for your vehicle, which, if the DIP switches are set correctly, will eliminate an error message with aftermarket LED turn signals. Up to 2 channels can be operated (front & rear or left & right).
If all four turn signals are replaced, 2 x CBW1 are required.
Requirements for use of the CBW1 on the vehicle: 1) LED indicators were installed on the vehicle in their original condition. 2) The vehicle has a CAN-BUS system.
If none of the requirements are met, the CBW1 will not be compatible.
Height = .39″ (11 mm) Width = 1.2″ (31 mm) (without brackets)
Width = 1.8″ (46 mm) (with brackets)
Length = 1.5″ (40 mm) Cable length = 7.8″ (200 mm) with pins
Yellow = Input channel 1 (+)
Orange = Output channel 1 (+)
Blue = Input channel 2 (+)
Red = Output channel 2 (+)
Gray = Input ground (-)
Black = Output ground (-)
Scope of delivery: 1 piece
Up to 2 channels can be operated.
A mounting tutorial can be found on YouTube on our channel (HIGHSIDER Tips & Tricks). Link: