The Highsider Apollo Run & Turn Signal Module not only sports a sleek design but also offers versatile mounting options: surface mounted, or flush-mounted. The Apollo includes a black aluminum ring with smoked lenses, a white DRL, and an amber turn signal. With this innovative lighting technology, 2 very bright SMD LEDs are installed in the center, enabling an extremely small design. The outer ring, on the other hand, consists of the new COB technology (Chip On Board). This also allows higher light values to be achieved than with conventional LEDs. This module comes with a black anodized aluminum ring that fits over the base body. E-approved. For front use.
A1: .5″ (13mm)
A2: .35″ (9mm)
D1: .87 (22mm)
D2: .79″ (20mm)
Thread bolt: M8 x .47 ” (12mm)
Black wire = ground (-)
Yellow wire = turn signal (+)
White wire: daytime running light (+)
Scope of delivery: 1 pair
Note: The unit can be installed flat without the aluminum ring, leaving only the lens visible. This requires drilling a .79″ (20mm) hole.
Accessory TIP: The Highsider PL Control Box CB2 (PN 208-109) switches the position light off during the flashing process and goes on again after the flashing process (with a small delay).