The Highsider Apollo Turn Signal Modules are suitable for mounting, fitting or molding into the desired fitment. The Apollo modules feature a black aluminum ring with smoked lenses and an 8mm mounting stud. With this innovative lighting technology, 2 very bright SMD LEDs are installed in the center, enabling an extremely small design. The outer ring, on the other hand, consists of the new COB technology (Chip On Board). Thanks to the new LED chip embedding for high-power LEDs, a very high luminance can be achieved with currently the best possible efficiency and service life. This also allows higher light values to be achieved than with conventional LEDs. This module comes with a black anodized aluminum ring that fits over the base body. E-approved for front and rear.
In the right direction – with the innovative turn signal series from HIGHSIDER. Don’t just show where you’re going, show who you are. This is trend-setting design at its best.
A1: .5″ (13 mm)
A2: .35″ (9 mm)
D1: .87″ (22 mm)
D2: .79″ (20 mm)
Thread Stud: M8 x .47″ (12 mm)
Black wire = ground (-)
Yellow wire = turn signal (+)
Supply: 1 pair
The unit can be installed flat without the aluminum ring, leaving only the lens visible. This requires drilling a .79″ (20 mm) hole.
Alternatively, the unit can be mounted with the aluminum ring on a retaining plate on the vehicle, see instructions.